Friday, March 25, 2016

BLT+ Balanced line tuner at Excalibur

Another portable test of the BLT+ tuner

KX3 operating on internal battery.  What a fantastic portable rig.

I took the BLT+ balanced line tuner out to the Excalibur antenna site to try it out on the doublet antenna that we put up last Saturday.  This was the first test of that antenna (40m and 80m using a common feedpoint).

I didn't have much time today and after the first QSO it started to rain so I packed up and left before getting as much documented as I would have liked.  I apologize for not recording the actual tuning process and the subsequent QSO.

BLT+ connected to open wire line (under the gloves) going to ta 40m Doublet at 65ft
I had the KX3 operating using its internal batteries and outputting 2w. I was running 2 watts because that is the most efficient PA mode for the KX3.

I used the BLT+ to tune the 40m/80m doublet.  Balanced line antennas perform better with a tuner designed for balanced line and this was a good test for both the tuner and the new antenna. 

Portable shack, courtesy of three plastic chairs

I quickly matched the doublet using the BLT+ using the lowest impedance setting which is also the most efficient.  I was glad to see that the BLT SWR LED indicator is bright enough to be seen in direct sunlight.  I was wondering about that but you can definitely tell when it dims even in direct sunlight.

Performance

After quickly tuning up I sent my call two times and was promptly answered.  The other station was running a Flex 6500 into a KPA500 and a OCF Windom at 50 feet. 

He reported me as 559, while he was a 599.  He was running a new KPA500 amp at 500w so we were a bit mismatched on power.  

Interestingly the difference in 2w and 500w exactly matches the 4 S-Unit difference in our reports if you do the math (each increase in an S-unit requires quadruple the power). 

AA4OO sitting back and listening to the QSO

Paul AA4XX kindly snapped some pictures while I was listening to the other operator.  This is the Excalibur antenna site but the shack is outside the photo. 

The Doublet's feed line has not been brought to the shack yet so I was just sitting under the antenna.  The open feed line is running along the ground for a bit which certainly didn't help the signal but we haven't installed the posts to carry the feed line over to the shack and I was too lazy to move the chairs far enough away to keep the feed line in the air.

In the foreground is some saw-grass common on the NC coast.  I'm not sure why it's growing this far inland.

Portable shack at the Excalibur antenna site... The Doublet is 65 feet above my head
Waiting my turn in the QSO... holding the Palm Single Paddle.  BLT+ tuner in the chair to the right

Video

Here is a brief video showing how the BLT+ is connected to the Doublet...


Summary

The little BLT+ performed great with both balanced line antennas I've tried.  It is easy to use and allows me to use my KX3 with balanced feed line antennas now.  I encourage you to build the kit from Pacific Antenna / QRPKits.com .

That's all for now

So lower your power and raise your expectations

72/73
Richard, AA4OO

No comments:

Post a Comment